NA7.10.3.2 Air-Cooled Condensers and Condenser Fan Motor Variable Speed Control

p.580NA7.10.3.2 Air-Cooled Condensers and Condenser Fan Motor Variable Speed Control

p.580Conduct and document the following functional tests on all air-cooled condensers.

p.580NA7.10.3.2.1Construction Inspection

p.580Prior to functional testing, document the following:

p.580(a) Verify that the minimum condensing temperature control setpoint is at or below

p.58070°F.

p.580(b) Verify that the master system controller saturated condensing temperature input is

p.580the temperature equivalent reading of the condenser pressure sensor.

p.580(c) Verify all drain leg pressure regulator valves are set below the minimum

p.580condensing temperature/pressure setpoint.

p.580(d) Verify all receiver pressurization valves, such as the outlet pressure regulator

p.580(OPR), are set lower than the drain leg pressure regulator valve setting.

p.580Appendix NA7 – Installation and Acceptance Requirements for Nonresidential Buildings and Covered Processesp.581

p.5812025 Nonresidential Appendices (e) Verify all condenser inlet and outlet pressure sensors read accurately (or provide

p.581an appropriate offset) using a pressure standard.

p.581(f) Verify all ambient dry bulb temperature sensors used by controller read accurately

p.581(or provide an appropriate offset) using temperature standard.

p.581(g) Verify all temperature sensors used by the controller are mounted in a location that

p.581is not exposed to direct sunlight.

p.581(h) Verify that all sensor readings used by the condenser controller convert or

p.581calculate to the correct conversion units at the controller (e.g., saturated pressure reading is correctly converted to appropriate saturated temperature, etc.).

p.581(i) Verify that all fan motors are operational and rotating in the correct direction.

p.581(j) Verify that all condenser fan speed controls are operational and connected to

p.581condenser fan motors to operate in unison the fans serving a common condenser loop.

p.581(k) Verify that all speed controls are in “auto” mode.