p.235The light source shall have a start time no greater than 0.5 seconds.
p.235JA8.4.4 Color Characteristics
p.235The light source shall meet the following CCT and color rendering requirements when measured in accordance with the test method of Section JA8.3.4:
p.235a) LED lamps regulated by the Title 20 Appliance Efficiency Regulations and subject
p.235to Color Rendering Index requirements under Title 20 shall comply with the Color Rendering Index requirements in Title 20.
p.235b) All other light sources shall provide a Color Rendering Index (CRI) of 90 or higher
p.235and color rendering R9 value of 50 or higher.
p.235c) All light sources shall be capable of providing a nominal Correlated Color
p.235Temperature (CCT) of 4000 Kelvin or less.
p.235JA8.4.5 RESERVED
p.235JA8.4.6 Dimming, Reduced Flicker Operation and Audible Noise
p.235The light source shall meet the following dimming, reduced flicker operation, and audible noise requirements when measured in accordance with the test method of Section JA8.3.7:
p.235a) The light source shall be dimmable down to 10 percent light output where 100
p.235percent full light output is defined as operating the light source at the maximum setting provided by the control.
p.235b) LED-based light sources designed to be connected with or dimmed by forward
p.235phase cut dimmers shall meet the requirements of NEMA standard SSL 7A.
p.235c) Light source in combination with specified control shall provide “reduced flicker
p.235operation” when tested at full light output as specified in JA10, where reduced flicker operation is defined as having percent amplitude modulation (percent flicker) less than 30 percent at frequencies less than 200Hz.
p.235d) Light source shall not emit audible noise above 24dBA measured at 1 meter from
p.235the light source when tested at full light output.
p.235e) Light sources shall also be tested and shown to comply with (c) and (d) while at
p.23520% light output.
p.235JA8.5 Marking
p.235Light sources meeting the requirements of this Appendix shall be marked with “JA8-2025” to indicate their compliance with the criteria of this Appendix. Light sources that have passed the “time to failure ” portion of the federal test procedures specified in Appendix BB to Subpart B of 10 C.F.R. Part 430 (2018) with a rated life of 15,000 hours or greater and that the ambient temperature for the test is maintained at 45 °C ± 5°C tolerance or at a manufacturer-selected temperature higher than 45 °C with ± 5°C tolerance shall instead be marked with “JA8-2025-E” to indicate that they comply with this Appendix and may additionally be installed in elevated temperature applications such as enclosed fixtures.
p.235Appendix JA8 – Qualification Requirements for High Luminous Efficacy Light Sources