NA1.2.1.2 Verification of Registered Documents

p.4712025 Nonresidential Appendices submittal of documentation to a Data Registry is required, the completed documents are referred to as registered documents, and the process of completing these documents by submitting information and certification signatures to the Data Registry is called registration.

p.471(b) All Certificate of Verification documents for applicable measures are required to be

p.471submitted for registration and retention to an approved Residential Data Registry.

p.471All submittals to the Data Registries shall be made electronically in accordance with the specifications in Reference Joint Appendix JA7.

p.471NA1.2.1.2 Verification of Registered Documents

p.471When document registration is required, printed paper copies or electronic copies of the applicable completed, signed, registered compliance documentation shall be allowed for use for required submittals to enforcement agencies, subject to verification that the information shown on the submitted document(s) conforms to the information shown on the current revision of the registered document(s) on file in the Data Registry for the building.

p.471The document registration Provider shall make document verification services available via phone, internet, or utilization of digital technologies, to enable enforcement agency officials, builders, installation contractors, ECC-Raters, and other authorized users of the Data Registry to verify that the information shown on submitted documentation is consistent with the information shown on the current revision of the registered document on file in the Data Registry for the applicable building.

p.471NA1.2.2 Summary of Documentation and Communication Procedures

p.471The documentation and communication process for measures that require field verification and diagnostic testing is summarized below. The subsequent sections of this chapter contain additional information and requirements that apply to all situations; however, the section on alterations, NA1.8, applies specifically to the differences in the requirements for alterations. NA1.7 applies specifically to the differences in the requirements for Third Party Quality Control Programs.

p.471(a) The documentation author and the principal mechanical designer shall complete the

p.471compliance documents for the building.

p.471(b) The builder or principal mechanical designer shall make arrangements for transmittal

p.471of a signed copy of the Certificate of Compliance, for units that require verification, to an ECC-Provider. The builder shall also arrange for the services of a certified ECC- Rater prior to installation of the duct system, so that once the installation is complete the ECC-Rater has ample time to complete the field verification and diagnostic testing without delaying final approval of occupancy by the enforcement agency. The builder or principal mechanical designer shall make available to the ECC-Rater a copy of the Certificate of Compliance that was approved/signed by the principal designer/owner and submitted to the enforcement agency.

p.471(c) When the installation is complete, the builder or the installing subcontractor shall

p.471complete and sign the Certificate of Installation, and Certificate of Acceptance, and post a copy of the completed signed Certificates at the building site for review by the enforcement agency in conjunction with requests for final inspection. Alternatively,

p.471Appendix NA1– Nonresidential Verification, Testing, and Documentation Procedures