JA8.3.3 Start Time Test

p.233JA8.3.3 Start Time Test

p.233Start time shall be measured in accordance with the Start Time Test Method as specified in Section JA8.7, subject to the following modifications:

p.233For lamps the reported value shall be the average start time of the tested units rounded to the nearest millisecond.

p.233For all other light sources, the reported value shall be the maximum start time of the tested units rounded to the nearest millisecond.

p.233For light sources that provide a fade-in feature, the initial plateau shall be the point specified in Section JA8.7.1.

p.233For light sources with a standby mode consuming no more than 0.2 watts of power, the start time test may be performed with the product receiving power and in this mode. In this case, the start time shall be the time between the sending of an on signal to the device via an appropriate control and the initial plateau.

p.233JA8.3.4 Color Characteristics Tests

p.233Correlated Color Temperature (CCT) and Color Rendering Index of federally regulated light sources shall be determined by the test procedures specified in 10 CFR 429 Subpart B and 10 CFR 430.23(gg).

p.233Correlated Color Temperature (CCT) and Color Rendering Index of non-federally regulated light sources shall be determined by the following test procedures, as applicable to the type of light source:

p.233a) Induction lamps: IES LM-66.

p.233b) LED light sources: IES LM 79.

p.233c) High intensity discharge lamps: IES LM-51.

p.233d) Other equipment: other applicable test procedure approved by the Executive

p.233Director.

p.233Nominal Correlated Color Temperature (CCT) shall be calculated in accordance with CIE 15 (reference document ANSI C78.377). Color Rendering Index (CRI) shall be calculated in accordance with CIE 13.3.

p.233The reported value shall be the average measured values of units tested rounded to be the nearest whole number for CRI.

p.233JA8.3.5 RESERVED

p.233JA8.3.6 RESERVED

p.233JA8.3.7 Tests for Minimum Dimming Level, Flicker, and Audible Noise

p.233Light sources shall be tested for flicker using Joint Appendix 10.

p.233The audible noise test shall be performed as specified in the Noise Test Method as specified in Section JA8.8.

p.233Appendix JA8 – Qualification Requirements for High Luminous Efficacy Light Sources