SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS (part 1 of 2)

p.437B. Walls.

Scanned crop of table from PDF page 440
Text in this table

Exception to Section 150.1(c)7Aib: Standard ducted systems without zoning dampers may comply with the minimum airflow rate by meeting the applicable requirements in Table-150.0-B or 150.0-C as confirmed by field verification and diagnostic testing in accordance with the procedures in Reference Residential Appendix Section RA3.1.4.4 and RA3.1.4.5. The design clean-filter pressure drop requirements of Section 150.0(m)12D for the system air filter device(s) shall conform to the requirements given in Tables 150.0-B and 150.0-C. c. The installer shall charge the system according to manufacturer’s specifications. Refrigerant charge shall be verified according to one of the following options, as applicable: I. The installer and rater shall perform the standard charge procedure as specified by Reference Residential Appendix Section RA3.2.2, or an approved alternative procedure as specified by Section RA1; or II. The installer shall perform the weigh-in charging procedure as specified by Reference Residential Appendix Section RA3.2.3.1 provided the system is of a type that can be verified using the Section RA3.2.2 standard charge verification procedure and Section RA3.3 airflow rate verification procedure or approved alternatives in Section RA1. The ECC-Rater shall verify the charge using Sections RA3.2.2 and RA3.3 or approved alternatives in Section RA1. Exception 1 to Section 150.1(c)7Aic: When the outdoor temperature is less than 55°F and the installer utilizes the weigh-in charging procedure in Reference Residential Appendix Section RA3.2.3.1 to verify the refrigerant charge, the installer may elect to utilize the verification procedure in Reference Residential Appendix Section RA3.2.3.2. If the verification procedure in Section RA3.2.3.2 is used for compliance, the system's thermostat shall conform to the specifications in Section 110.12. Ducted systems shall comply with minimum system airflow rate requirement in Section 150.1(c)7Aib. ii. Air-cooled air conditioners and air-source heat pumps, including but not limited to ducted split systems, ducted packaged systems, small duct high velocity systems and mini-split systems, which are of a type that cannot be verified using the specified procedures, with the requirements of Section 150.1(c)7Ai shall comply with Subsections a and b, as applicable. a. The installer shall confirm the refrigerant charge using the weigh-in charging procedure specified in Reference Residential Appendix Section RA3.2.3.1, as verified by an ECC-Rater according to the procedures specified in Reference Residential Appendix Section RA3.2.3.2; and b. Systems that utilize forced air ducts shall comply with the minimum system airflow rate requirement in Section 150.1(c)7Aib provided the system is of a type that can be verified using the procedures in Section RA3.3 or an approved alternative procedure in Section RA1. Exception 1 to Section 150.1(c)7A: Packaged systems for which the manufacturer has verified correct system refrigerant charge prior to shipment from the factory are not

Equation on PDF page 444: kWPV = kWdc size of the PV system

Equation text: kWPV = kWdc size of the PV system

Needs visual review

p.444
TABLE 150.1-A COMPONENT PACKAGE – Single-Family Standard Building Design p.445 Download CSV
Building Roofs andComponent CeilingsCZ 1CZ 2CZ 3CZ 4CZ 5CZ 6CZ 7CZ 8CZ 9CZ 10CZ 11CZ 12CZ 13CZ 14CZ 15CZ 16
Option Below (with AirB13 Roof Deck Insulation1,2 Space)NRNRNRR 19NRNRNRR 19R 19R 19R 19R 19R 19R 19R 19R 19
Option CeilingB13 InsulationR 38R 38R 30R 38R 30R 30R 30R 38R 38R 38R 38R 38R 38R 38R 38R 38
Option RadiantB13 BarrierNRREQREQNRREQREQREQNRNRNRNRNRNRNRNRNR
Option Ceiling AtticsC14 Insulation for VentedR 38R 30R 30R 30R 30R 30R 30R 38R 38R 38R 38R 38R 38R 38R 38R 38
Option Radiant AtticsC14 Barrier for VentedNRREQREQREQREQREQREQREQREQREQREQREQREQREQREQNR
Option C Roof Deck CathedralInsulation for Ceilings1,4R 38R 38R 38R 38R 38R 38R 38R 38R 38R 38R 38R 38R 38R 38R 38R 38
Low-Sloped Aged SolarRoofing Product ReflectanceNRNRNRNRNRNRNRNRNRNRNRNR0.63NR0.63NR
Low-Sloped ThermalRoofing Product EmittanceNRNRNRNRNRNRNRNRNRNRNRNR0.75NR0.75NR
Steep-Sloped Aged SolarRoofing Product ReflectanceNRNRNRNRNRNRNRNRNR0.200.200.200.200.200.20NR
Steep-Sloped ThermalRoofing Product EmittanceNRNRNRNRNRNRNRNRNR0.750.750.750.750.750.75NR
Equation on PDF page 444: CFA = Conditioned floor area

Equation text: CFA = Conditioned floor area

Needs visual review

p.444
Equation on PDF page 444: NDU = Number of dwelling units

Equation text: NDU = Number of dwelling units

Needs visual review

p.444
Equation on PDF page 444: A = CFA adjustment factor from Table 150.1-C

Equation text: A = CFA adjustment factor from Table 150.1-C

Needs visual review

p.444
Equation on PDF page 444: B = Dwelling unit adjustment factor from Table 150.1-C

Equation text: B = Dwelling unit adjustment factor from Table 150.1-C

Needs visual review

p.444

p.4373. Fenestration.

Equation on PDF page 443: kWPV = (CFA × A)/1000 + (NDU × B)

Equation text: kWPV = (CFA × A)/1000 + (NDU × B)

Needs visual review

p.443

p.443WHERE:p.444

p.434SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.435SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.436SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.437SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.438SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.439SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.440SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.441SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.442SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.443SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS

p.444SECTION 150.1 – PERFORMANCE AND PRESCRIPTIVE COMPLIANCE APPROACHES FOR SINGLE-FAMILY RESIDENTIAL BUILDINGS