7. Defrost.

p.507B. Insulation conductivity shall be determined in accordance with ASTM C335 at the mean

p.507temperature listed in Table 160.3-D, and shall be rounded to the nearest 1/100 Btu-inch per hour per square foot per °F. Fluid distribution systems include all elements that are in series with the fluid flow, such as pipes, pumps, valves, strainers, coil u-bends and air separators, but not including elements that are not in series with the fluid flow, such as expansion tanks, fill lines, chemical feeders and drains.

p.5066. Piping for space-conditioning systems, solar water-heating system collector loop, and distribution piping for steam and hydronic heating system shall meet the requirements of Section 160.3(c)1.

p.507C. Insulation protection. Pipe insulation shall be protected from damage due to sunlight,

p.5067. Defrost.

p.507moisture, equipment maintenance and wind. Protection shall, at minimum, include the following:

p.506A. If a heat pump is equipped with a defrost delay timer, the delay timer must be set to

p.506greater than or equal to 90 minutes.

p.507i. Pipe insulation exposed to weather shall be protected by a cover suitable for outdoor

p.506B. The installer shall certify on the Certificate of Installation that the control configuration has

p.507service. The cover shall be water retardant and provide shielding from solar radiation that can cause degradation of the material. Adhesive tape shall not be used to provide this protection.

p.506been tested in accordance with the testing procedure found in the Certificate of Installation.

p.507ii. Pipe insulation covering chilled water piping and refrigerant suction piping located

p.507outside the conditioned space shall include, or be protected by, a Class I or Class II vapor retarder. All penetrations and joints shall be sealed.

p.5068. Capacity variation with third-party thermostats. Variable or multi-speed systems shall comply with the following requirements:

p.507iii. Pipe insulation buried below grade must be installed in a waterproof and noncrushable

p.507casing or sleeve.

p.506A. The space conditioning system and thermostat together shall be capable of responding to

p.507D. Insulation thickness.

p.506heating and cooling loads by modulating system compressor speed.

p.507i. For insulation with a conductivity in the range shown in Table 160.3-D for the applicable

p.506B. The installer shall certify on the Certificate of Installation that the control configuration has

p.507fluid temperature range, the insulation shall have the applicable minimum thickness or R-value shown in Table 160.3-D.

p.506been tested in accordance with the testing procedure found in the Certificate of Installation.

p.507ii. For insulation with a conductivity outside the range shown in Table 160.3-D for the

p.506(c) Fluid distribution systems; common area space-conditioning systems. Multifamily buildings shall

p.507applicable fluid temperature range, the insulation shall have a minimum R-value shown in Table 160.3-D or thickness as calculated with Equation 160.3-A:

p.506comply with the applicable requirements of Section 160.3(a)1. Multifamily common areas shall comply with the applicable requirements of Sections 160.3(a)2A through 160.3(a)2J.

p.5061. Pipe insulation. Multifamily buildings shall comply with the applicable requirements of Sections 160.3(c)1A through 160.3(c)1D.

P1631#yIS1
Text in this figure

 

−      + = 1 PR

t 1 PR T

k K

p.507
Equation on PDF page 507: −      + = 1 PR

Equation text: −      + = 1 PR

Needs visual review

p.507

p.507(Equation 160.3-A)  

p.506A. General requirements. The piping conditions listed below for space-conditioning systems

p.506with fluid normal operating temperatures listed in Table 160.3-D shall have at least the amount of insulation specified in Section 160.3(c)1D:

p.506i. Space cooling systems. All refrigerant suction, chilled water and brine fluid distribution

p.506systems.

p.506ii. Space heating systems. All refrigerant suction, steam, steam condensate and hot water

p.506fluid distribution systems.p.507

p.506SECTION 160.3 – MANDATORY REQUIREMENTS FOR SPACE CONDITIONING SYSTEMS IN MULTIFAMILY BUILDINGS

p.507SECTION 160.3 – MANDATORY REQUIREMENTS FOR SPACE CONDITIONING SYSTEMS IN MULTIFAMILY BUILDINGS